Use for the removal of any floor finish or sealer that has been applied over resilient tile such as vinyl, vinyl composition, rubber, etc. This product is also recommended for use on hard surfaces such as terrazzo, quarry tile and brick. DO NOT USE on linoleum, asphalt tile, or tile in poor condition.
pH – 12.8 ± 13.9
Appearance – Clear, Light Orange Liquid
Fragrance – Light Solvent
Freezing Point – About 32°F
Solubility in Water – Complete
Flash Point – None
- Dilute at 16 oz. per gallon (1:8 ratio) or up to 32 oz. per gallon (1:4 ratio) of cool water.
- Apply the diluted solution of Superscope™ II using a clean mop. Let solution work for 5 minutes and do not let dry.
- Scrub using a black pad under a swing machine.
- Remove the remaining solution from the floor using a mop or wet vacuum. RINSE and INSPECT the floor for shiny spots. Repeat 2 and 3 if any finish remains on the floor.
SPECIAL PRECAUTIONS: Not for use on wood or painted surfaces. Before use on asphalt tile, linoleum or rubber test a small hidden area for any color change.
FOR INDUSTRIAL USE ONLY
IMPORTANT: Use only as directed. Do not mix with anything unless recommended since harmful conditions and poor performance could result. Do not pour unused product back into original container. All floors are slippery when wet. To prevent falls, exercise care when working and block off traffic with ‘Caution’ signs until floor is completely dry.
Water – 7732-18-5
2-Butoxyethanol – 111-76-2
Monoethanolamine – 141-43-5
Sodium metasilicate – 6834-92-0
Potassium hydroxide – 1310-58-3
Ethylene glycol phenyl ether – 122-99-6